In many cases.
Broom finish concrete driveway ideas.
Once the concrete has been trowelled smooth a large thin broom is used to create a textured finish.
Wait for the bleed water to evaporate.
The typical process for a broom finish is.
In this video we will show you how we broom finish concrete slabs.
Spread the resurfacer until it s between 1 8 and inch thick.
This is because the sealer will protect the concrete from road salts stains mold etc.
Some of the aggregate would be exposed giving you a nice smooth decorative look to your sidewalk and patio.
For a slip resistant finish wait 5 minutes then sweep a nylon bristle concrete broom across it 90 degrees to the foot traffic.
One is you could grind or polish the surface which would remove the rough broom finish and smooth the surface of the concrete.
Strike off with a screed.
After the concrete surface has been broom finished the scoring is created using a wide concrete tool that creates a smooth surface on both sides of the score joint.
There s some disagreement here.
This is a normal type of broom finish we do on a lot of patios pool decks sidewalks and driveways.
Remove the weatherstripping after 20 minutes.
Although with low water cement ratio exterior concrete with the proper amount of air there might not be.
Window pane concrete finish scoring can be combined with wide tooling of the surface to create a window pane effect.
A concrete sealer could be applied with some grit additive to keep it from being too slippery when it gets wet.
Broom finish driveway concrete driveways kmm decorative concrete northbridge ma.
Yes it is a good idea to seal the broom finished concrete.
This texture is great for around pools or areas that recieve water.
Broom finished concrete gets its name from the application of a broomed texture to the concrete as it is being finished.
Wait 6 hours before walking on it.