Push and hold the go button again when the paper light is on by itself release the go button.
Brother printer hl 5250dn drum light blinking.
To reset the drum counter press and hold down go for about 4 seconds until all the leds light up.
Once all four leds are lit release go.
The green status led will flash briefly while the printer is reset.
All leds will be off.
Close the front cover.
Once all four led s are lit release the go button.
If this does not clear the problem contact brother customer service.
Press the cover release button and then open the front cover of the printer.
The brother workhorse series scanners are designed for mid to large sized workgroups or high volume and batch scanning applications.
These robust reliable high speed scanners can facilitate digital transformation and easily integrate into your work environment.
Turn the printer power switch on while holding down the go button until the toner drum and paper leds are lit.
Make sure that the drum led is now off.
Brother strongly recommends that customers use only genuine brother drum units and or toner cartridges.
Each brother laser printer is designed to work at pre set temperatures that are matched exactly to each of our.
Press and hold down go button until all 4 leds are lit.
Be sure that the drum unit and toner cartridge assembly is installed in the machine before continuing.
When the toner light is on by itself release the go button.
Pressing the go button wakes up the printer from sleep mode to ready mode.
This faq explains the meaning of those different led indications.
When all the leds are off the power switch is off or the printer is in sleep mode.
Press and hold the go button on the front of the printer at the same time turn the printer power on.
I don t think i got the full yield from my high yield toner cartridge but the message toner life end or replace toner is displayed on the machine or the led is on or flashing.
Press the go button 8 times.
To reset the drum follow the instructions below.
Reinstall the drum and toner assembly into the machine and close the front cover.
Press and hold down the go button a small white piece on left side of the printer for about 4 seconds until all the leds light up.
The message should no longer appear.
Release the go button.
After the printer is reset the status led will be lit green.
